Graphic LCD 84x48 (Nokia 5110) Black on White for Arduino

Specification:

1. "LIGHT" linked with GND, the backlight to be lit.
2. Need you to compress the screen and PCB tighter, might got loose 

    after the delivery.

3. Use a 3.3V controller, otherwise the display could be quite vague.


LCD5110 Module:

Power supply voltage:2.7V-3.3V,5V is OK,

but part of the screen becomes black when tested

Data interface level:2.7-5V
Backlight power supply voltage:highest 3.3V
Installation diameter:2mm
Backlight:White

Document for Download:Data:

1．RST--------- reset
2．CE------------chip selection
3．DC-----------data/commands choice
4．DIN-----------serial data line
5．CLK------------serial Clock Speed
6．3.3V------------VCC
7．LIGHT--------- backlight control terminal
8．GND-----------power negative

Features:

84 X 48 dot matrix LCD,can show 4 lines of characters
Use serial interface communicate with the master processor,the number of 

interface signal line reduced greatly, only 8 signal lines including power and 

GND.Support different types of MCU,such as the SPI,MCS51 serial mode 0 

of AVR.Transfer rate up to 4Mbps,can full speed write display data without 

waiting time.

Can use the conductive glue to connect the module with the printed board, 

without connecting cable.The metal hooks on the module can fix the module 

on the printed board,which is very easy to install and replace.

LCD controller/driver chip has been bound to LCD chip,the volume of LCD is small
Low power supply,the working current in normal situation is lower than 

200μA,and has power-down mode.

Shipping Included:

1PCS*Nokia 5110 LCD Disply Module